Water Well Repair & Service in Springfield, MO

From the well cap to the pressure tank, we help Springfield-area homeowners reach independent, DNR-permitted contractors for well and pump problems. Call 417-759-4388 or send a request online.

  • Pumps, tanks & controls
  • Well caps & pitless adapters
  • Low yield & sediment problems

How your well system works

Most homes outside city water in Greene and Christian County use a drilled well with a submersible pump. Knowing the main parts makes it easier to describe a problem and understand what a contractor recommends.

  • Well cap: seals the top of the casing to keep out insects, rodents, and surface water.
  • Casing: steel or plastic pipe that lines the upper part of the well and seals off shallow groundwater.
  • Pitless adapter: the fitting where the water line leaves the casing underground, below the frost line.
  • Drop pipe, wire, and pump: the pump sits below the water level and pushes water up to the house.
  • Pressure tank and switch: store water under pressure and tell the pump when to start and stop.
How a private well system worksDiagram showing a drilled well with a cap, steel casing, pitless adapter below the frost line, drop pipe, submersible pump below the water level, and a water line to a basement pressure tank with pressure switch. Well cap Pitless adapter (below frost line) Steel casing Water level Drop pipe & pump wire Submersible pump Pressure tank Switch Ground Simplified illustration. Real well depths, casing lengths, and layouts vary.
A typical drilled well with a submersible pump. Water is pushed up the drop pipe, through the pitless adapter, and into the pressure tank in the house.

Well and pump services

Tell us what you need and we’ll connect you with an independent, DNR-permitted contractor who does that kind of work in your area. Not every contractor offers every service, which is part of why it helps to call.

Well pump repair & replacement

Submersible and jet pumps, control boxes, capacitors, wiring, and constant-pressure drives.

Well pump repair about Well pump repair & replacement

Pressure tank service

Recharging, diagnosing short cycling, and replacing waterlogged or leaking tanks.

Pressure tank repair about Pressure tank service

No water emergencies

When the taps go dry, start with safe checks, then reach a contractor.

No water help about No water emergencies

Pressure switch problems

Pitted contacts, clogged inlet tubes, and incorrect settings that stop the pump from starting or shutting off.

Pump & switch repair about Pressure switch problems

Well caps & pitless adapters

Cracked or loose caps, damaged casings, and leaking pitless adapters that can let contamination in.

Sediment, sand & low yield

Cloudy water, sand in fixtures, or a well that can’t keep up with demand.

Well disinfection after a bad test

If a test finds bacteria, a contractor can look for the cause and disinfect the well. Retest afterward.

Testing guide about Well caps & pitless adapters

Well plugging & abandoned wells

Unused wells must be plugged to Missouri DNR standards by a permitted contractor to protect groundwater.

Why local well construction matters

Springfield sits in karst country. Missouri DNR describes the region’s limestone and dolomite as full of sinkholes, caves, springs, and losing streams that can carry surface water underground quickly. A U.S. Geological Survey study of Greene County counted roughly 2,500 sinkholes and documented groundwater contamination from sources like sewage and fertilizer.

To protect drinking water, Missouri’s well construction rules for this area require bedrock wells to be cased below the confining layer that separates the shallow aquifer from the deeper Ozark aquifer. In practice that means deep wells, long casings, and pumps set far down. A damaged cap, a cracked casing, or a leaking pitless adapter matters more here than in many places, because it can open a path for surface water into the well.

Did you know? Wells drilled in Missouri after July 31, 1987 should have a state record. Our guide shows how to look up your well’s record, which often lists its depth and construction date.

Well service FAQ

What does a well service visit usually include?

It depends on the problem, but a contractor typically checks the pressure switch and gauge, the pressure tank’s air charge, the electrical supply and controls, and the pump’s amperage. They may also check the well cap and look for leaks or signs of contamination.

Do you help with well drilling?

Our focus is repair and service for existing wells and pumps. If you need a new well drilled, call and tell us where the property is. We’ll let you know honestly whether we can connect you with a driller in your area.

Who regulates private wells in Missouri?

The Missouri Department of Natural Resources sets well construction standards and permits well drillers and pump installation contractors. Water testing is handled through the Missouri State Public Health Laboratory and local health departments.

Need help with your well?

Call or send a request. Tell us your town and what the water is doing, and we will connect you with an independent local well and pump contractor.

Ozark Well Pros is an independent referral service, not a well drilling or pump installation contractor. We connect homeowners with independent, Missouri DNR–permitted well and pump contractors, who set their own pricing, schedules, and warranties.

Call 417-759-4388Request Service